Video: September Update and Steam Bending Basics
In general I try to start and finish one phase of building before I move onto the next. This summer, however, I have let things stray a bit. Some of […]
Category Archives: interior
Steam box #1 and Steam Bending Fail #1 and #2
My first steam box is the simplest. The steam box was very simple and fun to make. It is basically a 4 inch ABS tube, sealed at one end with […]
Stripping the Fore Interior
Last week I worked on cutting out the captain’s window and cleaning up any issues I had in the front of the boat. Today I gave myself the green light […]
Interior Planking Coming Along
These 1/2 sheets of 4mm marine plywood take more muscle than I thought. The snap-back tension is so much greater than 1 1/2 inch strips. These guys can’t wait to […]
Placed and Epoxied First Interior Hull Pieces
After lots of sanding to true up the interior lines I was able to put down 24 inches of interior hull on the port side. I have battens running up […]
Dry-fitting First Interior Plank
I may be getting ahead of myself, but… I want to see if this thin marine ply will behave in big 24 inch wide “planks” on the interior. I cut […]
