Starting to Strip Again

This time it’s a smaller radius curve, so a little trickier. I’m still using 1/4 inch Okoume marine plywood cut to 1 1/2 inch by 8 foot strips.
Lateral pull is greater than before, so I’ll segment the stripping more and use even narrower strips at the very end of each small run.
I’m also using more drywall screws than before. I need the hold down strength. I just need to be careful and back everything out before the epoxy is fully cured. Should be fine.

20131011-094328.jpg

One response to “Starting to Strip Again

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s